Hey everyone, AZ build team here (Unit 1).

I was running into some difficulties when trying to correct the zeroing of the CEM40 mount. I zero’d, took the top apart, moved the screw, put it back together, and tried to zero again. It still searches for the zero position in the original ‘forward’ orientation versus ‘sideways’. Is this normal? I interpret the instructions as after moving the screw it should automatically find a new zero point 90 degrees from the original. Is it supposed to zero that way automatically or when you calibrate are you supposed to move it to the new position and accept it? I’ve tried a few different ways (including moving during calibration) and it always seems to default back to the forward-facing direction instead of the new one. The only time I could get it to go sideways was if I did the “Set zero position”, moving it sideways roughly 90 degrees, and using the “Go to zero position” function. But, the “search for zero position” still goes forward. Hopefully that all makes sense.

Thanks for the help!